Otostick Ear Corrector

Otostick Ear Corrector

BrandsOtostick
Product Code:OTO-A-1
Availability:In Stock
  • $19.99

    • x3  $22.99/unit
    • x6  $21.99/unit
    • x10  $19.99/unit

Otostick Ear Corrector | Cosmetic Instant Correction for Prominent Ears | 8 units

Otosctick Ear Corrector is a cosmetic ear corrector for protruding ears consisting of a transparent, hypoallergenic silicone prosthesis for external use that is attached to the back of the ear and the adjacent part of the head by means of a special adhesive in order to naturally keep the ear in the right position. Painless and with no side effects.

How to use Otostick Ear Corrector:

The product is very easy to use once you get used to put it on. The ear correctors normally last 1 week after the adjustment period,  
When you use Otostick continuously, keep in mind that the ear will resist changing to its new position, now aesthetically correct. Initial adaptation to the use of a new device usually takes 2 to 6 weeks approximately.

What do you need to keep in mind using Otostick Ear Corrector:

Someone else should put the product into place.
Clean skin thoroughly before each use. You may need to use an astringent to remove any traces of grease.
The two adhesive sides of the corrector (the one which goes on the ear and the one which goes on the head) should be placed in parallel, without any deviation of one over the other.
Just as it happens with other corrective products, an adjustment period may be required.
Use continuously and properly in order to test the effectiveness of the product.
In some cases you may need to wax the area in order to get a better result.
Use on wet skin can reduce the effectiveness of the adhesive.
Remove the corrector once a week so as to clean and moisturize exposed skin thoroughly.
Use a cotton swab impregnated with body oil or skin moisturizer to remove the corrector. Lift the edge of the corrector and gradually get the swab between the skin and the corrector (under the corrector) until it has been completely removd. Repeat the same process on both sides of the corrector.
Room temperature during placement should be 25 °C approximately, otherwise the adhesive may not set properly, thus resulting in lasting less time.
Keep placement temperature for several hours, after which time the product will withstand a rise in temperature and contact with water.

Write a review

Note: HTML is not translated!
   Bad           Good